Philip Martel (@pomartel)
When I sighed up for the conference, I filled out the form down until the checkbox where I would agree to the privacy policy. I clicked on the link to check out...
Please clarify for me:The output of your micro-bolometer system is 14-bit raw data. Your ISP needs 12-bit data, but you can use non-linear data. You spoke of...
One think you didn't state is what sort of input your ISP expects. If it is expecting raw monochrome video, then the simplest approach would be to just drop the...
In this case calling your data "f(t) = 1 for some particular values of t" may be leading you astray. Consider it to be t(n) for n = 0, 1, 2,... That is what you...
From https://www.mathworks.com/help/matlab/ref/rand.htm X = rand returns a single uniformly distributed random number in the interval (0,1).exampleX = rand(n) returns...
I believe rand(1,N) produces an 1 by N matrix of random numbers where each is uniformly distributed between 0 and 1. Why should the correlation of two non-zero...
Reviewing the app note for the XADC, https://www.xilinx.com/support/documentation/appli...they are assuming that the input to the XADC is an RC circuit with the...
Re: Why am I getting the same frequency response plots when one has aliasing and the other does not?
Aliasing occurs when there is a frequency component higher than Fs/2. Why are you surprised that you get aliasing?
We were interested in tracking vehicles. The signals had frequency peaks that varied with the type of vehicle, speed. and so on. In general the peaks were well...
Just calibrating the amplifiers won't be enough. The sensors will need to be calibrated also. I used to work with DOA of acoustic signals. We calibrated the...
Use this form to contact pomartel
Before you can contact a member of the *Related Sites:
- You must be logged in (register here)
- You must confirm you email address
