Roger Golsby (@RogerG)
No I'm not familiar with FPGA but will check it out. Thanks for the info.I am looking at using my analogue signal generator with an adc to produce an spdif signal...
No I haven't been very clear.I built a triamp which includes a signal filter to provide the three frequency bands, high, medium and low. Each signal is then attenuated...
I am working on a project to use a digital front end for my triamp. I am struggling to work out how to decode an incoming spdif audio signal. Is a phase locked loop...
Thanks Adam,It's very new to me so I have quite a lot of researching to do based on your info and the other replies.Roger
Thanks, yes I think I will use C or C++. It will be another learning curve for me. When I did the program for my audio amp attenuators and LCD display I ended up...
I would want to do the design myself, that's my nature. Although I have mainly used assembly for the 18 series pics I have also C. I found assembly better as I felt...
I did look at the DSPic33CK but wasn't sure. That's good from what you have said and I may well try it. My problem is that it takes me a long time to design things...
Thanks for that, have been putting off using surface mount but I know I have to do it. One twitch with the tweezers and it's gone, but will be a challenge.
Use this form to contact RogerG
Before you can contact a member of the *Related Sites:
- You must be logged in (register here)
- You must confirm you email address
