Hi,
I'm having problems with RTDX, using the C6711 DSK. When I finish to load
the project, I receive the message:
RTDX target applucation does not match emulation protocol!
Loaded program was created with an rtdx library which does not match the target
device.
I've already read about this problem, and the solution was to set the RTDX
configuration to JTAG, but, in my case, it isn't working. It is already set
to JTAG, but I still receive this message. Can anyone help me?
Thanks,
RTDX problems...
Started by ●November 16, 2005
Reply by ●November 16, 20052005-11-16
I get the same error when I move from a project that was developed for
a DSK and than use it inside the simulator. To resolve teh issue, go
to the DSP/BIOS setting and change the RTDX to simulator. In your
case you say you have already changed the value so I am not sure what
you should do. You can send me the project and I can take a look if
you wish.
Shlomo.
--- In c6x@c6x@..., farmorbiolo@y... wrote:
>
> Hi,
>
> I'm having problems with RTDX, using the C6711 DSK. When I finish
to load the project, I receive the message:
>
> RTDX target applucation does not match emulation protocol!
> Loaded program was created with an rtdx library which does not
match the target device.
>
> I've already read about this problem, and the solution was to set
the RTDX configuration to JTAG, but, in my case, it isn't working. It
is already set to JTAG, but I still receive this message. Can anyone
help me?
>
> Thanks,
>
a DSK and than use it inside the simulator. To resolve teh issue, go
to the DSP/BIOS setting and change the RTDX to simulator. In your
case you say you have already changed the value so I am not sure what
you should do. You can send me the project and I can take a look if
you wish.
Shlomo.
--- In c6x@c6x@..., farmorbiolo@y... wrote:
>
> Hi,
>
> I'm having problems with RTDX, using the C6711 DSK. When I finish
to load the project, I receive the message:
>
> RTDX target applucation does not match emulation protocol!
> Loaded program was created with an rtdx library which does not
match the target device.
>
> I've already read about this problem, and the solution was to set
the RTDX configuration to JTAG, but, in my case, it isn't working. It
is already set to JTAG, but I still receive this message. Can anyone
help me?
>
> Thanks,
>