Hello list,
please i need urgent help on this. Does anyone know what would the error below
mean?
>CPU_1-DSP Device Driver
>
>Trouble Halting Target CPU:
>Error 0x80000020/-1070
>Fatal Error Execution.
>An unknown error prevented the emulator from accessing the processor in a
>timely fashion.It is recommended to RESET EMULATOR. This will disconnect
>each target from the emulator. The targets should then be power cycled
>or hard reset followed by an emureset and reconnect to each target.
>
>
Reset emulator options halt the whole CCS application.
Any ideas are really welcome.
Thanks in advance!
Andreas Kotsopoulos
University of Athens
Dept. Electrical & Computer Engineering
Greece
Connection Fatal error
Started by ●July 4, 2005
Reply by ●July 4, 20052005-07-04
Dr. Kotsopoulos-
> please i need urgent help on this. Does anyone know what would the error
> below mean?
>
>>CPU_1-DSP Device Driver
>>
>>Trouble Halting Target CPU:
>>Error 0x80000020/-1070
>>Fatal Error Execution.
>>An unknown error prevented the emulator from accessing the processor in a
>> >timely fashion.It is recommended to RESET EMULATOR. This will
>> disconnect
>>each target from the emulator. The targets should then be power cycled
>>or hard reset followed by an emureset and reconnect to each target.
Please give a problem description. What is the target board? What OS?
Is it JTAG over PCI bus, parallel port, USB port? If not an EVM or other
plug-in board, then what type of emulator? What code was running when the
error occurred (or was it a power-up situation)?
-Jeff
> please i need urgent help on this. Does anyone know what would the error
> below mean?
>
>>CPU_1-DSP Device Driver
>>
>>Trouble Halting Target CPU:
>>Error 0x80000020/-1070
>>Fatal Error Execution.
>>An unknown error prevented the emulator from accessing the processor in a
>> >timely fashion.It is recommended to RESET EMULATOR. This will
>> disconnect
>>each target from the emulator. The targets should then be power cycled
>>or hard reset followed by an emureset and reconnect to each target.
Please give a problem description. What is the target board? What OS?
Is it JTAG over PCI bus, parallel port, USB port? If not an EVM or other
plug-in board, then what type of emulator? What code was running when the
error occurred (or was it a power-up situation)?
-Jeff