Hi folks,
I work on C6412 DSP.
I have this requirement: when dsp receive a particular command from an
extern device, my software must to place the dsp into a known good
state (same as after hardware reset).
Have C6412 a software reset or a particular register that put the dsp
into a known good state?
Thanks all
Regards
Gio
Software Reser for DSPC6412
Started by ●September 5, 2008
Reply by ●September 8, 20082008-09-08
Presciutti,
Im not too familiar with the 6412, however...
Most of the TI DSPs have two step method of resetting the watchdog timer.
and if the correct second step, the watchdog timer will force a reset.
R. Williams
---------- Original Message -----------
From: "presciutti_dgl2k"
To: c...
Sent: Fri, 05 Sep 2008 14:58:33 -0000
Subject: [c6x] Software Reser for DSPC6412
> Hi folks,
> I work on C6412 DSP.
> I have this requirement: when dsp receive a particular command from an
> extern device, my software must to place the dsp into a known good
> state (same as after hardware reset).
> Have C6412 a software reset or a particular register that put the dsp
> into a known good state?
>
> Thanks all
> Regards
> Gio
------- End of Original Message -------
Im not too familiar with the 6412, however...
Most of the TI DSPs have two step method of resetting the watchdog timer.
and if the correct second step, the watchdog timer will force a reset.
R. Williams
---------- Original Message -----------
From: "presciutti_dgl2k"
To: c...
Sent: Fri, 05 Sep 2008 14:58:33 -0000
Subject: [c6x] Software Reser for DSPC6412
> Hi folks,
> I work on C6412 DSP.
> I have this requirement: when dsp receive a particular command from an
> extern device, my software must to place the dsp into a known good
> state (same as after hardware reset).
> Have C6412 a software reset or a particular register that put the dsp
> into a known good state?
>
> Thanks all
> Regards
> Gio
------- End of Original Message -------