serial programming

hi
is there any way to program C2x or related families without any emulator or debugger card
i just want to know that can i program this devices with com port
or program them with an EEPROM

_____________________________________ Start a New Thread

Hi,

according to C2x documentation, you can boot directly from SPI (serial
port) or eCan module if your dsp have one.
_____________________________________________________________________________________
Alain SALMETOZ | APC by Schneider Electric | IT Business |
Firmware design Engineer senior
Phone: +4 76 18 33 59 ext. 3359 |
Email: a...@mgeups.com | Site: www:apc-mge.com | Address:
140 avenue Jean Kuntzmann, INOVALLEE - Montbonnot St Martin, 38334 Saint
Ismier cedex
*** Please consider the environment before printing this e-mail

"ilovedebiangnu"
Envoypar : c...
10/05/2009 13:50

A
c...
cc

Objet
[c28x] serial programming

hi
is there any way to program C2x or related families without any emulator
or debugger card
i just want to know that can i program this devices with com port
or program them with an EEPROM

_____________________________________ Start a New Thread

You can use SDFlash for serial programming, see ref. guide Start a New Thread

Hi, all
I am looking for an FFT routine for F2808, which functions like the routine in dsplib for 5000/6000 DSP. Does TI provide this function?
thanks

Chao Xiang

_____________________________________ Start a New Thread

TI does provide these FFT routines in assembly
these assembly they claim is C callable
but when i tried to use FFT library for 2812, it did not work
best of luck
-Chirag
--- On Tue, 4/8/09, Xiang Chao wrote:
From: Xiang Chao
Subject: [c28x] FFT in 28x
To: c...
Date: Tuesday, 4 August, 2009, 7:05 PM


Hi, all
I am looking for an FFT routine for F2808, which functions like the routine in dsplib for 5000/6000 DSP. Does TI provide this function?
thanks

Chao Xiang

_____________________________________ Start a New Thread