AD535 | BIOS | Booting | Bootloader | C621 | C6211 | C6415 | C671 | C6711 | C6711DSK | C6713 | CCS | Chassaing | COFF | DAT | DM64 | DM642 | DMA | DSK671 | DSK6711 | EDM | EDMA | EMIF | Emulator | EVM | EVM620 | FFT | FIR | GPIO | Halting | HPI | HWI | IDK | JTAG | LDB | LDH | LDW | Linker | LMS | LOG_printf | Matlab | McBSP | MEM_alloc | MIPS | PCI | PCM3003 | Pipeline | Profiling | QDM | Reset | ROM | RTDX | Sampling | SDRAM | Stack | TEB | THS1206 | TMS320C621 | TMS320C6416 | TMS320C6711 | TMS320C6713 | UART | Vector Table | XBUS | XDS560

Hi All,

I have read the documents about PCI in the folders of the DM642 in the
TI site. But I found some troubles to understand what I should do for
configure the DM642 as a slave and I would like to do some questions:

If, the DM642 is a slave, the task of the configuring the registers is
make by the master?

What are the registers that I (SLAVE) have to configure?

Tank you for yours time

Best regards 
Modo

(You need to be a member of c6x -- send a blank email to c6x-subscribe@yahoogroups.com )